sewinginshambles

my crazy life

Bustle Tutorial- Sort of

In a previous post, I showed a picture of the blue and brown bustle dress I’ve been working on. On my Facebook page, I had a couple friends ask how I managed to make it. Now I don’t profess to be an expert by any means, and there are millions of ways to drape a bustle, but this is how I did mine. (Coincidentally, it was easier to write this and make a second bustle than the first, 3o minutes versus about 9 hours of fussing)

So mini tutorial, ready set go!

Fabric, pins, scissors, measuring tape, thread, and of course your victim. Mine happens to be an American girl doll that was near my sewing table.

When I made the brown bustle, I used about 2 yards of 45 inch wide fabric. It is a synthetic taffeta, and since I didn’t want a hem weighing it down, I just singed the edges until they melted a bit. You can line your bustle if you would like, just bag line it or flat line it and finish the edges with bias tape, it’s all up to you really. For the doll’s bustle, I just took the dimensions of the brown bustle and shrunk them down using some questionable math techniques and ended up with a waist band of 2 inches by 12 inches and the bustle part of 14 inches by 20 inches. Disclaimer, I did not finish the edges on this bustle in the pictures, because I’m terribly lazy and this was just a mock-up to show how I made it.

So essentially two rectangles, super fancy I know. Also, forgive the super wrinkly fabric, this was just made from scraps

Mark the center back on the larger rectangle, and make tailor tacks or just mark about every three to five inches (I did about every eight-nine inches on the brown one. Again it’s up to you, depending on how many pleats you want and how deep you want them) I marked the measurements with an orange sharpie just to make sure it was clearly shown. I wouldn’t suggest it on your expensive fashion fabric.

Mark center back and where you want the bustle skirt to start on the waistband, I started mine near the sides, rather than in front.

Pleat the skirt onto the waistband, sew it together then flip the waistband down and slip stitch it together so there are no raw edges showing.

Yes my thread was green, just to make it easier to see what I was stitching to what. Now here’s the draping-ish part. With the first finger and thumb of your left hand, pinch the first mark you made on the skirt closest to the waistband.

Like so

With your first finger and thumb of your right hand, pinch the second mark you made on the skirt and bring together, transferring both pleats to your left hand so your right hand is free to grab the next pleat.

Continue this pattern with all of the markings, bring them all together and pin it while you prepare to stitch them together. Make sure you have each pleat lined up with the others, or you could skip a pleat without intending to while sewing.

I just whip stitched them together, but you could put loops on the inside of the skirt to allow the pleats to be pulled up or down.

Stitch that section to the center back of the waistband or you could attach a hook and eye to allow it to be pulled up or down.

Attach hooks and eyes to the waistband and you’re done!Well, what do you think? Are there any other inventive ways you’ve discovered to make a bustle without complicated instructions that make you want to scream?

 

Cheers!

Advertisements

Single Post Navigation

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: